Fuel Tank Trailers and Fuel Skids: Sizes, Pumps and the Rules to Check

Fuel Tank Trailers and Fuel Skids: Sizes, Pumps and the Rules to Check

A fuel skid is a tank on a fork-pocket base that rides in a truck bed or on a flatbed. A fuel tank trailer has the tank built onto its own running gear. We list a Boss FT-200 skid with two 100-gallon tanks and a 15 GPM pump. Check hazmat and CDL rules for your fuel and volume.

Key takeaways

  • A skid rides on something else; a trailer rides on its own axles. The skid needs a truck bed or flatbed and a forklift to move it. The trailer just hitches up.
  • Capacity jumps a lot between the two. Today’s stock runs from a 2 × 100-gallon skid to 590- and 990-gallon Boss tank trailers.
  • The pump kit is half the decision. Listings range from a 15 GPM pump on the skid to 25 GPM 12V and 30–45 GPM gas-engine pumps on the trailers.
  • Rules depend on your fuel, volume, vehicle and trip. Below are the questions to check with a hazmat compliance professional or your state DOT.

Every unit below is on the lot at our Reno, TX store as of this writing. Stock changes daily, so treat these as examples and verify on the exact trailer or skid.

Fuel skid vs. fuel tank trailer

Both put fuel where the work is. The difference is how the tank gets there.

Fuel skidFuel tank trailer
MountingTank(s) on a flat base with fork pockets; sits in a truck bed or on a flatbed trailerTank built onto its own frame, axles, coupler and lights
Capacity in today’s stock2 × 100 gal (Boss FT-200)590 gal and 990 gal (Boss)
Moving itLoad and unload with a forklift or loader forksHitch to a bumper-pull ball and go
Empty weight (as listed)865 lb2,500 lb to 4,500 lb
Who it suitsSmaller equipment, a pickup that’s already headed out, lower volumeLarger fleets, more machines per trip, higher volume

A skid is the simpler, smaller setup you can swap between trucks. A tank trailer is a self-contained rig with its own brakes, lights and storage.

Fuel Tank Trailers and Fuel Skids: Sizes, Pumps and the Rules to Check

What comes on a fuel skid

Our fuel tanks on skid category currently shows one unit: the Boss FT-200 2 × 100 gal fuel tanks on skid, #03091 (Reno, $4,830 as listed). Here’s what the listing includes:

  • Tanks: two 100-gallon smooth plate tanks, 10 gauge smooth plate floor and side walls.
  • Skid: 49″ W × 74″ D × 5″ H with fork pockets.
  • Pump and hose: a “Pit Stop Fueling Combo” with a 50′ hose reel, 15 GPM pump, auto nozzle and filter kit.
  • Power: battery kit with a 12V battery and plastic battery box, plus a 7-watt solar panel charger.
  • Plumbing: 1″ fittings at the bottom front of each tank, a 1″ drain at the back, a fuel gauge on top and two 2″ fill ports (one with a ventable cap, one with a plug).
  • Weight: 865 lb empty.

The 15 GPM pump is the smallest in today’s lineup, which suits topping off a few machines. Measure your truck bed or deck against the 49″ × 74″ footprint.

Remember that 865 lb is empty weight. Add the fuel you plan to carry, then check that total against your truck’s payload or the flatbed’s rating.

Fuel tank trailers

Every Boss tank trailer listed below is a two-axle bumper pull with a 2-5/16″ Demco coupler, Dexter NEV-R Adjust brake axles, a front enclosed cabinet and a 28″ tongue extension the listing calls ready for a DEF setup. Each of these listings states: “Tank is designed exclusively for Farm Use to Transport Diesel Fuel.” Plan your use around that. If you have something else in mind, talk to us first.

590 gallons, 10K. The 2026 Boss 590 gal GVWR 10K tank trailer #03322 lists a 590-gallon carbon steel tank with two baffles, a 25 GPM 12V GPI pump with 20′ hose, auto nozzle and #10 micron filter, and a charging kit with a 5 amp trickle charger. It rides on two 5,200 lb axles, weighs 2,500 lb and lists a 7,490 lb payload against a 9,990 lb GVWR. A 60″ × 24″ × 12″ tool cage sits behind the tank.

990 gallons, 14K. Three Boss 990-gallon units (model FT990072) are listed, all on two 7,000 lb axles with a 14,000 lb GVWR and a 990-gallon smooth plate square tank with three baffles:

  • #03381: 30 GPM Kohler electric-start gas engine pump, 35′ hose on a spring retractable reel. 3,100 lb empty, 10,900 lb payload.
  • #03770: 45 GPM Briggs & Stratton gas engine pump, 35′ reel, 7-watt solar charger and a 60″ × 24″ × 34″ rear enclosed cabinet. Listed at 14′ long and 5′ wide, 3,100 lb empty, 10,900 lb payload.
  • #03188: 45 GPM Briggs & Stratton pump, 35′ Cox reel, a 100-gallon Enduraplas DEF kit, an extra-large front cabinet, an 8″ channel frame upgrade and a 60″ × 28″ × 34″ rear cabinet. 4,500 lb empty, 9,500 lb payload.

Payload is GVWR minus empty weight, as shown on each listing. Check your truck’s towing and hitch ratings against the trailer’s loaded weight, not its empty weight.

Sizing: 100–200 gallon setups vs. larger trailers

Start with how you fuel today:

  • How many machines, and how big? A couple of tractors or a skid steer is a different job from a spread of equipment running all day.
  • How often can you refill the tank? If the fuel supplier is close, a smaller tank and more trips may work. If it’s far, more gallons per trip helps.
  • What will carry it? A skid needs a truck bed or flatbed with room and rating to spare. A trailer needs a truck rated to tow it full.
  • How fast do you need to pump? In today’s stock, 15 GPM (skid), 25 GPM 12V (590), and 30 or 45 GPM gas engine pumps (990s).

In broad terms, the 200-gallon skid fits lighter, lower-volume fueling. The 590- and 990-gallon trailers fit bigger operations that want more fuel per trip and a faster pump. Gallons also drive which rules you’ll need to check.

Fuel Tank Trailers and Fuel Skids: Sizes, Pumps and the Rules to Check

Rules to check before you haul fuel

We’re a trailer dealer, not a compliance office, so this section doesn’t tell you what applies to your setup. It lists questions to check and the federal rule behind each. Take them to a hazmat compliance professional or your state DOT.

How is the fuel classed, and is the tank “bulk”?

The federal Hazardous Materials Regulations (HMR) treat fuel by hazard class. Under 49 CFR 173.150(f), a flammable liquid with a flash point at or above 100°F that meets no other hazard class may be reclassed as a combustible liquid.

What applies next depends on the packaging. A combustible liquid in non-bulk packaging isn’t subject to the HMR unless it is a hazardous substance, hazardous waste or marine pollutant. In bulk packaging, a listed set of requirements still applies, including shipping papers, marking, ID numbers, placarding, incident reporting, training and emergency response information.

49 CFR 171.8 defines bulk packaging for a liquid as a maximum capacity greater than 119 gallons.

Questions to ask: How is my fuel classed? (Its safety data sheet and your supplier are a starting point.) Is each tank I’m carrying over 119 gallons? If it’s bulk, which of the listed requirements apply to my trip?

Do the materials-of-trade limits fit what I carry?

49 CFR 173.6 covers “materials of trade” carried by motor vehicle. For a Class 3 material in Packing Group II or III, each packaging is limited to 8 gallons (30 L). The aggregate gross weight of all materials of trade on a vehicle generally can’t exceed 440 lb (200 kg).

Questions to ask: Does anything I carry fit these limits? These per-packaging limits are far smaller than a 100-gallon tank, so ask how they relate to any skid or trailer setup before you rely on them.

Does the farm provision apply to me?

49 CFR 173.5 covers agricultural operations. One part covers moving an agricultural product to or from a farm, within 150 miles of the farm. It sets aside some requirements (emergency response information, training and specific packaging rules), not all of them, and only when every condition is met:

  • The farmer is an intrastate private motor carrier.
  • No more than 502 gallons (1,900 L) of a liquid agricultural product is on a single motor vehicle.
  • The movement and packaging are specifically authorized by a state statute or regulation in effect before October 1, 1998.
  • Everyone who handles or prepares the product has been instructed in the applicable requirements.

The definition of “agricultural product” in 49 CFR 171.8 includes fuel whose end use directly supports producing an agricultural commodity.

Questions to ask: Is my use agricultural under that definition? Is the trip intrastate and within 150 miles? Is the volume on the vehicle within 502 gallons? Does my state have the required authorization? Which requirements still apply?

Do I need a CDL, and does “tank vehicle” apply?

Under 49 CFR 383.5, a combination vehicle is a Group A commercial motor vehicle when its gross combination weight rating or weight is 26,001 lb or more, including a towed unit over 10,000 lb. A vehicle of any size can also be a commercial motor vehicle if it carries hazardous materials as defined there (materials required to be placarded).

Fuel Tank Trailers and Fuel Skids: Sizes, Pumps and the Rules to Check

The same section defines a tank vehicle as a commercial motor vehicle designed to carry any liquid or gas in a tank or tanks with an individual rated capacity over 119 gallons and an aggregate rated capacity of 1,000 gallons or more, permanently or temporarily attached. 49 CFR 383.93 requires a tank vehicle (N) endorsement to operate one. It separately requires a hazardous materials endorsement to operate a commercial motor vehicle used to transport hazardous materials as defined in 383.5.

Questions to ask: What’s the GVWR of my truck plus the trailer’s GVWR? Does my load need placards? What’s the rated capacity of each tank, and what’s the total across every tank on the rig? Does every tank count toward that total? Does my state offer any farm-related licensing provisions?

Fuel skids and tank trailers at Centerpoint

Here’s what’s in stock at our Reno, TX store today:

UnitCapacityPump (as listed)GVWREmpty weightPayloadPrice (as listed)
Boss FT-200 skid #030912 × 100 gal15 GPM, 50′ reeln/a (skid)865 lbn/a$4,830
2026 Boss 590 gal #03322590 gal25 GPM 12V, 20′ hose9,990 lb2,500 lb7,490 lb$12,100
2026 Boss 990 gal #03381990 gal30 GPM gas engine, 35′ reel14,000 lb3,100 lb10,900 lb$15,780
2026 Boss 990 gal #03770990 gal45 GPM gas engine, 35′ reel14,000 lb3,100 lb10,900 lb$16,100 (sale)
2026 Boss 990 gal #03188990 gal + 100 gal DEF kit45 GPM gas engine, 35′ reel14,000 lb4,500 lb9,500 lb$18,650 (sale)

Prices and stock change, so check before you drive out.

FAQs

Do I need a CDL to pull a fuel tank trailer?

It depends on weights, what you haul and the tanks. Federal rules look at whether the truck-and-trailer combination is rated at 26,001 lb or more with a trailer over 10,000 lb, whether the load needs placards, and whether the rig meets the “tank vehicle” definition. Check your exact truck, trailer and fuel with your state licensing office or a compliance professional before you tow.

Can I haul diesel in a fuel skid in my pickup?

A skid like the FT-200 is built to sit in a truck bed, but whether and how you can haul fuel in it is a compliance question. The answer can turn on how the fuel is classed, each tank’s capacity, the total on the truck and whether the trip is farm-related. Check with a hazmat compliance professional or your state DOT, then check the skid’s full weight against your truck’s payload rating.

What size fuel skid do I need?

Count your machines, estimate how much they burn between refills, and factor in how far you are from your fuel supplier. Today our skid stock is the 2 × 100-gallon Boss FT-200. If you need more per trip, the 590- and 990-gallon tank trailers are the next step up.

Is a “non-hazmat” fuel trailer free of all rules?

Don’t assume so. A “non-hazmat” label in a trailer’s name may describe how the unit is built or marketed. It doesn’t tell you which rules apply to your fuel, volume or trip. Federal hazmat, CDL and state rules can still come into play. Ask a hazmat compliance professional or your state DOT about your exact setup, and ask us what the manufacturer says about the unit.

Talk to us

Bring your machine count, how often you refuel and your truck’s ratings to our Reno, TX store. We’ll walk you through capacity, pump speed and weights on the exact skid or tank trailer. You also get 90 days of free service after your purchase. If you’re spreading out the cost, see trailer financing, or contact us.